You need a silicon tab, scissors, threader, and a piece of heat shrink tubing. I use ~ a 2" piece of 1/8th heat shrink tubing - one end cut at an angle. Cut the amount of strands you are tying off the tab and cut off the tab end on one side. Slide your threader into the flat end of the tubing. Run the loose legs through the threader. Pull the threader back out and all the legs should be hanging out.
I clamp the end of the tube while tying so the legs don't move around too much while tying the legs to the jigs. Legs are manageable when you are tying UL jigs.

Name: IMG_4248.jpg Views: 635 Size: 57.7 KB

Roundhead 1/80th & custom 1/64th chub head #12 Matzuo sickle (custom #10 gap)
6 strands.