twin units

Quote:

---

Originally Posted by BigRiverMarine

I have 3 Touch 12's in the Ranger. Two at the dash and one up front. I use GPS/Sonar on one unit and Structure Scan side and down on the other at the dash. Gives you a much bigger picture that way. Adding a mega 10 at both the dash and front to run Lakemaster card and 360. Not going to use the sonar, SI, or DI on these two.


BRM

---

I'm thinking about the same bill,adding humminbird 360 at the bow[emoji3]

Sent from my SM-S903VL using Tapatalk

Quote:

---

Originally Posted by dr crappie

So one unit runs on the puck transducer for 2d and the other unit runs on the structure scan transducer for side and down view with both of them linked together was wanting to set 2 units up on the bow was wondering how you set them up I'm guessing one runs off of the transom transducer just linked to a unit at the dash

---

My lowrance are nema 2000 and ethernat connected.You can view any transducer you want at any unit,I have 2d and lss1's front and back.It will also share mapping,one map card will run all 3 units.You can even share gps any way you want,9 and 7 are using internal gps and using heading info from point one mounted by the big motor.My hds 10 at the console is using the point one for gps and heading.

Sent from my SM-S903VL using Tapatalk

So if want to put 2 different brand units how do you hook them up I'm guessing one has to be run off of a transom mount transducer the other on the trolling motor

:ThumbsUp