Likes Likes:  0
Thanks Thanks:  0
HaHa HaHa:  0
Results 1 to 1 of 1

Thread: N2K questions

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 03-07-2014, 03:37 PM #1
    Flint
    Flint is offline Trophy King II
    Join Date
    Dec 2010
    Location
    Kansas
    Posts
    331
    Post Thanks / Like

    Default N2K questions

    I started to install my new HDS8 LSS2 unit and uncovered my old N2K connector for the LGC3000 ant which served my Global map 5200C. It has one four way connector with ant in and out, with a dummy load on each end. The old network power wire is on the down stream cable that goes into the global map.
    I want to upgrade to the point 1 antenna and run the global map and the HDS8 from the one antenna. So I would obviously need the antenna which is supposed to come with one T connector and a four foot cable which should be long enough for me. I now assume I would need a N2K starter kit mainly for the power node since the old setup was powered through the 5200C cable. So now do I also need a new cable for the 5200C or can I just dead end the old power wire? Or will the power back feed from the 5200c and power the network without having to buy the power node/starter kit?
    Last edited by Flint; 03-07-2014 at 04:24 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

BACK TO TOP