Bass Tracker Owners

[Downwind]

Pulling a new transducer cable (Trying that is) Can't seem to get passed a blockage of some sorts. Any one have an ideas? I have a string tied to the end but no luck on getting it pulled.
Even tried a fish tape but it's hanging up too.

Thanks!

[ezgo]

Pulling a new transducer cable (Trying that is) Can't seem to get passed a blockage of some sorts. Any one have an ideas? I have a string tied to the end but no luck on getting it pulled.
Even tried a fish tape but it's hanging up too.

Thanks!

What side are you trying to get passed, I found there are stiffeners in the walls and only have like a one inch hole in them at the top. I have one on the front of the boat that I hid the wire behind my carpet and when I got to the back there is a small opening that I put the wire threw and went around the stiffener in the rear with a big opening to the batteries

[ezgo]

Sorry I forgot to add that my tracker is an 01 pt 185. I have had same issues I need to get a six gauge wire down the boat for my 24 volt troll motor.

[Downwind]

Going down the drivers side and to the back. Trying to run it through the fuse box where the old one came out of. Naturally the old one came out smooth as butter. Also have the 185 98 model.

[wilbur]

IF you are trying to go from the counsole to the front you have to pull the deck. If you go from console to back pull side panel by controls and there is about a 2jn. piece of plastic conduit run it through there and you fill have to hook it with something through the oblong hole on the right side wher the cables comr through. It helps to pull the light bracket out so you can see better. Not that hard.

[Downwind]

Boys ~~~~~ She came through!!!!! Ate a bit of supper, gave it a another pull and low and behold she slid like slick tires in a mud hole!! Glad that's over with. Thanks for the suggestions! You guys are good people!

[majflyboy]

Good ending.

[beagle man]

outstanding