Likes Likes:  0
Thanks Thanks:  0
HaHa HaHa:  0
Results 1 to 3 of 3

Thread: HB 565 transducer repair

  1. 03-20-2010, 10:42 PM #1
    bamagillslayer's Avatar
    bamagillslayer
    bamagillslayer is offline Slabmaster
    Join Date
    Mar 2010
    Location
    Athens Alabama
    Posts
    96
    Post Thanks / Like

    Default HB 565 transducer repair


    Can these be repair. Will fishing today my dad hit a stump because of the wind and cut the cable. This was the second time I had used it on the water. Just my luck get a new fish finder and it get damaged. Any help will be appreciated.
    Reply With Quote Reply With Quote
  2. 03-21-2010, 09:54 AM #2
    talltimber
    talltimber is offline Crappie.com 1K Star General
    Join Date
    Apr 2007
    Location
    Bloomfield, Missouri, United States
    Posts
    1,619
    Post Thanks / Like

    Default

    I spliced one on a Wide 128. Two wires twisted together and soldered, heat shrink. Shield/bare soldered. Heat shrink over all.
    Reply With Quote Reply With Quote
  3. 03-23-2010, 11:27 AM #3
    Humminbird_Greg's Avatar
    Humminbird_Greg
    Humminbird_Greg is offline Crappie.com 2K Star General * Crappie.com Supporter
    Join Date
    May 2007
    Location
    Eufaula, AL.
    Posts
    2,186
    Post Thanks / Like

    Default

    The 565’s transducer should have an additional wire or two in it but yes it can be fixed and if done properly you will never know that it had been damaged. Solder heat shrink and seal as Talltimber posted. Be sure to replace the noise shielding correctly too.
    Greg Walters at Humminbird
    [email protected]
    I help because I can
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

BACK TO TOP