Interlink

Printable View

Show 40 post(s) from this thread on one page

01-23-2010, 09:04 AM
wannagofishin

Quote:

Originally Posted by mduncan62

As long as you have both units participating fully with the interlink, they'll both see the waypoint.

When the Ice clears up there, I'll try to set up a weekend day that we can meet up there and I'll run you through it, and show you the best place to fish during winter on Smithville. Shady lakes cove.

That would be great - may take you up on that - although it sounds like it may still be a while :mad: Have you gotten your new rig out?

So, it sounds like I just need to figure out how to make sure the two units are "participating" and I'll be good to go.

Thanks!
01-23-2010, 09:10 AM
Fisherman_Wantabe

Quote:

Originally Posted by wannagofishin

That would be great - may take you up on that - although it sounds like it may still be a while :mad: Have you gotten your new rig out?

So, it sounds like I just need to figure out how to make sure the two units are "participating" and I'll be good to go.

Thanks!

It will ask you how you want to partcicpate when all is connect correct and the unit is powered up.
01-23-2010, 10:31 AM
wannagofishin

Thanks Fisherman...that's what my problem must have been when I was playing around with them in the garage the other day. I uploaded the new software for both, and was playing around...when I went to Interlink, it only showed the unit I was on..BUT, I only had the one on each time. I will turn both on and play around a bit more :)
01-23-2010, 11:17 AM
Fisherman_Wantabe

Quote:

Originally Posted by wannagofishin

Thanks Fisherman...that's what my problem must have been when I was playing around with them in the garage the other day. I uploaded the new software for both, and was playing around...when I went to Interlink, it only showed the unit I was on..BUT, I only had the one on each time. I will turn both on and play around a bit more :)

They may have changed something because the best I remember if the unit seen the interlink when powering up it would ask about sharing with just one unit at a time on.
But I also have the weather link module so it may be due to that, but I'm pretty sure it would ask when powering up either unit.

Show 40 post(s) from this thread on one page