route a transducer cable on a powerdrive motor

[Fishinman91]

I thought someone had posted some pictures of how they mounted thier transducer on thier powerdrive TM but i cannot find it.

I just put a new powerdrive TM on my boat and dont know the best way to keep the transducer cable out of the way. With the old TM, i just ran the cable up the shaft. With the powerdrive this is not possible because the shaft slides through the mount.

Any ideas? ...pics would be great also.


fishinman.

[Shellback]

I just have it wire tied on the collar where the shaft goes into the motor housing, and another at the top, leaving a little slack in it to slide around the mount. I have it running down the left side of the shaft. Where it leaves the shaft, I have it running thru the cenrer of the coiled wire.

[must buy my fish]

Thats how I've run mine. Their's not many ways to run them on this tm but that looks to be the best.

[blueball]

look at the stickeys on the top of elect. and trolling motor page ,some really good instal info

[Fishinman91]

look at the stickeys on the top of elect. and trolling motor page ,some really good instal info

Those were the pictures i was looking for....thanks a bunch. And thanks to everyone else for helping.


Fishinman