Plastic problem fixed!!!!!!!

The guys in the top video are Jerry Van Sickle [left] from Do-It Molds and Tommy Skarlis, walleye and crappie tournament pro angler. I know both personally. Great guys and just flat out full of know-how.

Thanks Ifish i have look at the one Bears has but the pop off tip don't know about. Does anyone have one with the pop off tip? Then the one lurercraft has will the threads hold up with the screwing on and off. Plus don't know the diameter of the one Bears has. The one i have is the Basstackle love the way it's made it is just too big around u have a 1 1/4" 1/2" thick plug after each shot. When u shoot two molds and have this much remelts with 6oz of plastic u are remelting more than injecting. Like i shot a 100 Baby shad tonight only reheated once. My homemade injector has very little waste, if i keep it hot i can push the waste out without taking it a part. Bob this Do-it plastic is very good can't believe no bubbles and no turning i will be ordering 2 1/2 gallon before long. And yes it is my Monkey Milk made about 300 Shad last two days just trying out this new plastic.Cub48

I have the pop off tips and love them.

I went ahead and ordered the injector from Lurecraft. I have not got to use it yet but everything look good. The tip is tapered on the end and is also 5/8" round this should fit both of my molds. It is the right size around, inside looks to be about 3/4" or less. Hope to get to try it out tonight. Cub48