new plastic bait

[snake River]

my crawdad mold coming in today it is listed on the website These little guys are inch and a half long.

[huntinslabs]

Can you shoot these in 2 colors? If so how would it split? Would it be tail/head& claws?

[snake River]

Can you shoot these in 2 colors? If so how would it split? Would it be tail/head& claws?

yes to your question we can shoot them and 2 colors I haven't got that far so let me mess with it I'm assuming that I can tear off the tail and of the crawdad and make it a color in the clause on the front would be a different color we will post some when I get to it.

[pondhopper]

Hey snake you can laminate that little dude . Had that mold for months . Just put a piece of tin foil between the mold halves . Shoot open , peel out one half leaving the half body only. Close the mold normally without tin foil shoot again . Nice Really nice baits that way .

[jaxsprat]

That crawdad is really neat, looks like it could be action plus.................

[crappieseeker]

looks good

[snake River]

Hey snake you can laminate that little dude . Had that mold for months . Just put a piece of tin foil between the mold halves . Shoot open , peel out one half leaving the half body only. Close the mold normally without tin foil shoot again . Nice Really nice baits that way .

you do not have to use tinfoil I use the backside of the mold against the cavities to shoot one half make sure that you clean the surface thoroughly on the backside of the mold with acetone or alcohol.

[snake River]

you guys were asking about 2 color crawdads take a look at this we will be doing vertical shooting later on.

[snake River]

That crawdad is really neat, looks like it could be action plus.................

I haven't had a chance to try them out in the water but I'm sure that this bait has plenty of action on the front.

[snake River]

looks good

thank you .