in the process of making the baby Shad Stinger and three colors . We had definitely are having quite a time . The process of making these is very simple but the problem is getting the them to attach to the tail but we go through the process. First of all we cut the tail of the baby Shad Stinger and replace it back into the mold and then we put a back other in the mold and we put the mold back to gather and try to shoot the belly to attach everything else. The problem is that we do not have enough hot liquid to go down to attach the tail properly they were pulling off right and left . I've enclosed a picture of what happened. We definitely wanted to pass this on to all you guys in plastic baits and to my customers. I apologize recently for trying to do something that I should a research better you will run about 1% in the mold of holding together on the tail. The rest would pull off. So we are no longer going to even try to shoot three colors on the baby Shad Stinger I have enclosed a picture of my mishap in again I apologize to everyone for something I should've researched a little bit better.[/IMG]