The PVC pipe is 1 1/4--- 24 inches---The holder at the top is cut from a piece of 6 inch water pipe---this pipe is 1/4 inch thick--The cap is made to fit on top.-----The screw is 1 1/2 X 1/4 inch with 2 washers----1/4 inch flat nut and a 1/4 inch tap nut.
I use the tap nut on the top cause you can tighten it down pretty good and will not loosen up, but still swivel the holders. Bolts, nuts and washers all 1/4 inch.
Sorry for taking up so much space--If there is a easier way just holler.
I made 8 of these Rod holders for about 15-20 bucks---when I am done and on my boat I will take another photo.


Likes:
Thanks:
HaHa: 

Reply With Quote
















